Chaos 600 Thread

[Nuttcaze]

Buy it Here - http://www.scaleflying.com/Chaos-600-Size-Electric-Helis_c_225.html

More Info Here - http://www.myrcguides.com/Chaos_600.html

Manual here - http://www.myrcguides.com/files/Chaos600Manual2011.pdf


Features
■Electric Power System
■Carbon Fiber  Frame
■Pre-Painted Fiberglass Canopy
■Carbon Fiber Tail Blades
■Triple-Bearing Block Main Shaft Support
■Fully Driven Tail Auto Rotation System
■High Efficiency Torque Tube Tail Drive System
■Push-Pull Control Linkage
■Rear Tail Servo Mount
■10mm Hollow Main Shaft
■8mm Spindle

Specification:
Length: 1200mm(47.25 in)
Height: 388/405mm(15.25 in/16 in)
Main Blade Length: 600mm
Main Rotor Diameter: 1350mm(53.15 in)
Tail Rotor: 240mm(9.45 in)
Motor Drive Gear: (15 and 16T) 6mm shaft
Main Drive Gear: 170T
Autorotation Tail Drive Gear: 180T
Tail Drive Gear: 40T
Drive Gear Ratio: 1:17.0:4.5/1:15.45:4.5
Weight(w/o main blade): 1340g
Flying Weight: Approx 3000g(6.6 lbs)

[Nuttcaze]

Some flight videos

[old_city_painter]

Just a few pics of my Chaos 600 build.  Very nice machine once I got the bugs worked out!

[Nuttcaze]

What issues did you run into? The only issue I had was needing to sand little bits of the base plate to get it to fit properly. Other then that it went together really good. 

[old_city_painter]

Marc,  I had 2 issues...the frame sides were not drilled equal to each other, could not fit the boom block and the main rotor head block was drilled off center.  Cliff made good on both issues.  The heli flies great.  Thinking about a Bell 222 or a Jet Ranger like yours, only I like the black, red and silver one!