Hey Guys, So, i took my clone out this past week. And crashed!! Not hard. But, i did break the seesaw arm inside the flybar cage. I did some debating on wheather to swap out my clone head with the head from my HK450. Or order and wait. Decided to swap. No biggy! Got the swap all done without to much hastle. ( always have a little trouble getting the gear hole and the shaft hole to line up. ) Anyway, i go to install the flybar. Only one problem! It appears that i was sent a flybarless head! The kit came with a flybar and paddles. But, the cage has screws, in the holes that the flybar should go thru. I pulled one of the screws out and tried to put the flybar thru. But, the hole is treaded, of course. I guess i'm just wondering if this bird is still going to fly?? I know it is probably a dumb question!! Just looking for some piece of mind that it will still fly. Thanks for any input guys!!