Its nice to see there is still some of you people still around and also still some Esky 900 fans.
Anyway I was asked if I would give a bit of my Esky 900 setup. Why well I am not sure but
you can still purchase the kits even if the parts are hard or non existant it looks like there are
still some lovers of these fine heli's.
Parts listed are the ones I used to build and are still in my first orange built Esky 900 even the canopy
is the original though its got a couple of holes and cracks its still on and this heli still flys like a rocket
and is as gentle as a kitten.
The not so hard list
1/ Motor Turnigy c3548-1100 these had the 4mm shaft so thats why I started with this one and I found it
to be a winner for my heli.
These are nolonger made or available from HobbyKing there is
another one its a SK35-42 1250kv but its got a 5mm shaft I think you would have to just look around.
All my Esky 900 have the c3548-1100 fitted.
2/ ESC Hobbywing Pentium 60amp with bec. or similar
3/ Gyro Align gp780 ( I just like these and I use them on all my Align & Esky Heli's)
4/ Servo's Esky Digital 36gram on swash === and Align DS520 on the tail
5/ Battery Turnigy 3.300mah or 5.000mah 4cell 14.8v or somethink similar.
6/ Radio Spectrum Ar6200 receiver with the remote receiver.
I have found that these heli's have allways been good on the above setups so if it works why change it.
I have never tried these with a 6cell setup as I never seen a need to.
Anyway it's all a little bit to late now that Esky are not making them anymore
proberly why I have shifted to all my Align heli's and also my planes.
Anyway enough for now nice chatting again,
By for now ,